Hyundai 2008 Elantra Manuel d'utilisateur télécharger pdf (Page 212)

511

Driving your vehicle

Automatic transaxle operation

The highly efficient automatic transaxle

has 4 forward speeds and one reverse

speed. The individual speeds are select-

ed automatically, depending on the posi-

tion of the shift lever.

All normal forward driving is done with

the shift lever in the D (Drive) position.

To move the shift lever from the P (Park)

position, the brake pedal must be

depressed with the ignition switch ON.

✽✽

NOTICE

The first few shifts on a new vehicle, if

the battery has been disconnected, may

be somewhat abrupt. This is a normal

condition, and the shifting sequence will

adjust after shifts are cycled a few times

by the TCM (Transaxle Control

Module).

For smooth operation, depress the brake

pedal when shifting from N (Neutral) to a

forward or reverse gear.

WARNING - Automatic

transaxle

• Always check the surrounding

areas near your vehicle for peo-

ple, especially children, before

putting a car into D (Drive) or R

(Reverse).

• Before leaving the driver’s seat,

always make sure the shift lever

is in the P (Park) position; then

set the parking brake fully and

shut the engine off. Unexpected

and sudden vehicle movement

can occur if these precautions

are not followed in the order iden-

tified.

CAUTION

• To avoid damage to your

transaxle, do not accelerate the

engine in R (Reverse) or any for-

ward gear position with the

brakes on.

• When stopped on an upgrade, do

not hold the vehicle stationary

with engine power. Use the serv-

ice brake or the parking brake.

• Do not shift from N (Neutral) or P

(Park) into D (Drive), or R

(Reverse) when the engine is

above idle speed.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 359 360

Commentaires sur ces manuels

Pas de commentaire